The proper operation of the washing machine largely depends on how it was installed. It is important to arrange it not only conveniently, but also without biases and distortions. In this article we will take a closer look at how to evenly install the washing machine yourself, without calling the wizard. First of all, you need to choose a place where the SM will stand. In order not to make a mistake in the correct location, you should analyze all the possible options.
Where to install the AGR
There are several recommendations, following which you can find the best place to install:
- All communication washers should be located next to each other.
- Install the machine on a perfectly flat floor.
Even after choosing a location, you cannot be sure that the machine will not jump and vibrate. Therefore, you need to proceed to the next step - adjusting the legs. Read on for tips on how to level your washing machine.
How to adjust the legs of the washing machine
Vibrations are a serious problem that can cause irreparable harm: they lead to violations of screws, bolts and other fasteners in the machine. Vibrations also cause frequent damage to the plastic tank - if it bursts, water will pour. To prevent all these problems from happening, you need to tighten the legs on the washing machine.
Improper installation threatens not only to break the washing machine, but also to damage surrounding objects. The machine can budge with strong vibrations.
Smooth and proper installation is ensured by special leveling feet provided by the manufacturers of SMA.
To increase or decrease the height, screw the leg into the housing or unscrew it from it. These actions will help to level the machine without much effort.
No need to immediately twist the legs as much as possible.
Important points when adjusting the legs
Understanding how to adjust the washing machine, you can tighten or unscrew the legs by setting it in a level position. To check the tilt of the SMA, you will need to adjust the washing machine by level. It can be used to measure deviations.
- Place the tool on top of the washer housing.
- Apply the level so that it is parallel to the walls of the machine. The bubbles in the flasks should be within its lines. The same applies to installing the tool parallel to the side walls.
- A deviation in either direction is evidence that the legs of the washing machine need to be adjusted. How to do this - we have already figured out.
On how to properly adjust the legs, there is a lot of video on the network. To cope with this task, use one of them:
Phased installation of the machine
By correctly installing and connecting the washer, you will ensure the quiet operation of the washing machine. Following the instructions, everyone can cope with the installation of CM:
- Before installation, remove the rear wall and remove the transport bolts. They securely fix the drum, preventing loosening.
- Choose a place where the surface is flat and hard. It is here that it is best to install a washer. Soft rubber mats should not be used. If the SMA is installed incorrectly, then at high spin speeds it will make a lot of noise and vibrate, staggering in all directions.
- Then plug the washer into a grounded power outlet. In this case, the washing will not be accompanied by unpleasant noises and buzzing.
An analysis of how to balance the washing machine guarantees a safe and long service. The washing machine will work silently, without “running away” from anywhere. There is nothing easier than installing a machine in the bathroom, in the kitchen or in the back room. Compliance with recommendations on how to adjust the washing machine is a guarantee that many problems can be avoided in the future.