Is there a mistake in the Gorenie refrigerator? This happens when a system malfunction occurs. Then the self-diagnosis displays an error code on the display, or the indicators blink on the panel. How to determine the meaning of characters? There is an instruction manual for this, as well as our article.
Gorenje DTC
As soon as you notice a malfunction on the scoreboard, reboot the equipment to eliminate a system failure. How to do it:
- Unplug the refrigerator for 10-15 minutes.
- Plug in again.
- Look at the scoreboard.
Do the icons glow? Then start decoding and troubleshooting.
Error code | What does it mean | Do-it-yourself troubleshooting |
E2 | The EP4 unit on the control panel does not reach the signal from the freezer compartment sensor. | Diagnostics of the temperature sensor is carried out. The integrity of the wiring is checked, the contacts are tightened. In case of breakage, the sensor must be replaced. |
E4 | The EP4 does not receive the message again, but now from the refrigerator compartment sensor. | Sensor check, wiring replacement, installation of a new part. |
E6 | It happens in refrigerators with one temperature sensor for two chambers. It does not signal EP4. | The actions are the same as in previous cases. |
In the event of a breakdown, the Combustion unit may respond by flashing indicators.
The light blinks | What happened | How to fix the problem |
3 | In the refrigerator compartment, the NTC sensor does not work. | Inspection of parts, contacts, wiring. Install a new item if necessary. |
4 | Blinks at 0.5 Hz. The freezer temperature sensor is malfunctioning. | Repair and replacement. |
2 Hz. Problems with the operation of the E72 module (EEPROM). | Ringing all the details of the module. For repair, it is better to contact a specialist. | |
5 Hz. Faulty controller or temperature sensor in the freezer compartment. | See solution for bulb 3. | |
5 lights up continuously. | The “Quick Freeze” mode is set. | After turning off, the light goes out. |
6 | The temperature in the freezer compartment is above normal. | What to do:
|
To avoid troubles, adhere to the operating rules:
- Install the refrigerator away from heating appliances, stoves.
- Connect only to a grounded outlet with an RCD circuit breaker.
- Thaw and clean the appliance once every six months.
- Do not fill shelves with hot food.
If you cannot find the fault yourself, and the error does not disappear from the screens, contact a service center.